Epson Pro 9000 Printer Manual page 59

3-4 | Maintaining and Transporting the Printer
If you're using EPSON paper, leave this setting on
If you're using other media, enter the thickness value of the paper in
0.1-mm increments by pressing the
4. Press the button to save the setting.
Enter
appears on the display.
5. Press the button to print the full series of alignment patterns.
Enter
If you want to print a single alignment pattern, press the + or – button
until the pattern number appears. Then press the
For the EPSON Stylus Pro 9500, skip to the next section,
•
"Completing the Alignment Procedure."
For the EPSON Stylus Pro 9000, patterns 1 through 3 are printed
•
on the first sheet of paper. After this sheet is printed,
appears on the display and the red
6. Raise the paper set lever and remove the printed sheet. Even though the
light is flashing, it is safe to raise the paper set lever.
Operate
7. Load another sheet of paper. The next three patterns are printed.
8. Repeat steps 6 and 7 twice, until all 12 patterns have been printed.
9. Raise the paper set lever and remove the last printed sheet. Then lower
the lever and continue the alignment procedure in the next section.
3-4
.
STD
or button.
+ –
ADJUST. PATT.= ALL
button.
Enter
PAPER OUT
light comes on.
PAPER OUT