Epson Pro 7600 Unpacking And Setup Manual page 17

6. Set the paper lever to the released position.
7. Insert the paper into the paper insertion slot.
8. Pull the paper down through the paper
insertion slot so that it comes out below.
Note:
If the roll paper does not come out, follow the
instructions below.
Adjust the feed strength by pressing the
Paper Feed buttons on the control panel.
When using thick, heavy, or curled paper,
press the Paper Feed (u) button to increase
the power. When using thin on light paper,
press the Paper Feed (d) button to decrease
the power.
If the paper does not come out even after
executing the procedure above, open the front
cover and pull the paper out manually.
9. Holding the bottom edge of the paper, turn the
roll paper to remove slack. Make sure that the
bottom edge of the paper is straight, and that
it is aligned with the rows of the holes.
10. Set the paper lever to the secured position, and
close the roll paper cover.
11. Press the Pause button. The printer heads
move and the paper automatically feeds into
the printing position. READY appears on the
LCD panel.
Note:
Even if you do not press the Pause button, the print
heads move and paper feeds into the printing position
automatically. READY appears on the LCD panel.
Now you are ready to print on roll paper. Make
the printer driver settings, then send the print job.
Note:
Allow time for the ink to dry thoroughly after
printing to ensure the printout quality.
If you do not use the paper set above, remove it from
the printer. When you use roll paper, set the paper
lever to the released position, and wind it up. When
you use cut sheet, remove the paper from the printer
and store it separately.
15