Unpacking The Printer - Epson Pro 7600 Unpacking And Setup Manual

Place the front rubber legs of the printer
just at the end of the desk.
Leave enough room (over 600 mm) in
front of the desk.
Prevent your printouts from getting dirty
or crinkled.
Use a grounded power outlet. Do not use a
damaged or frayed power cord. Avoid using
an outlet that is shared with other appliances.
Use only an outlet that meets the power
requirements of this printer.
Operate the printer under the following
conditions:
Temperature: 10 to 35 °C
Humidity: 20 to 80% without condensation
Avoid locations that are subject to direct
sunlight, excessive heat, moisture, or dust.
Do not block the ventilation openings.
Avoid locations near potential sources of
interference such as loud speakers or cordless
phones.
Avoid locations near TVs, radios, air
conditioners, or humidifiers.
Avoid locations that are subject to shocks or
vibrations.
Keep the printer away from combustible
substances.
Keep the printer away from dusty areas.

Unpacking the Printer

c
Caution:
The printer unit is heavy and unwieldy.
Have two people unpack the printer.
1. Open the box containing the printer and
remove the cardboard panel, the accessory
box (A), the roll paper spindle with roll paper,
and the polystyrene foam (B) around the
printer unit.
B
2. Remove the fixers from the sides of the box.
Lift the box up and away from the printer,
then fold it and set it aside.
3. Remove the cardboard panels.
A
B
9