Jenn-Air JFI2089AEP User Instructions page 9

Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
The recommended settings should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
A
A. Touch pads
Temperature Controls
For your convenience, your temperature controls are preset at
the factory. When you first install your refrigerator, make sure the
controls are still set to the recommended set points.
Press the touch pad next to "FRESH FOOD TEMP" on the
main menu to display the current set point of the
compartment. Press the touch pad next to "WARMER" or
"COLDER" to adjust the set point to the recommended 38°F.
Press the touch pad next to "Done" to lock in the setting.
Press the touch pad next to "FREEZER TEMP" on the main
menu to display the current set point of the compartment.
Press the touch pad next to "WARMER" or "COLDER" to
adjust the set point to the recommended 0°F. Press the touch
pad next to "Done" to lock in the setting.
To Turn Cooling Off/On:
Cooling On/Off controls all cooling functions, the control panel
and the dispenser. It does not disconnect power to the
refrigerator.
Press and hold the On/Off button for three seconds. The LED
will light up to indicate that cooling is Off. Neither
compartment will cool.
Press the On/Off button again to turn on the cooling. The LED
will turn off.
Adjusting Controls
The FRESH FOOD TEMP control adjusts the refrigerator
compartment temperature. The FREEZER TEMP control adjusts
the freezer compartment temperature.
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The display will show the set point for approximately 3 seconds.
Press the touch pad next to "WARMER" or "COLDER" to
adjust the set point to the desired temperature. Then, press
the touch pad next to "Done" to lock in the new set point
temperature.
NOTE: Except when first turning on the refrigerator, do not adjust
either temperature control more than one setting at a time. Wait
24 hours for the temperature to stabilize between adjustments.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little ice
A
REFRIGERATOR too cold
FREEZER too cold
Options
Door Alarm
The Door Alarm feature sounds an audible alarm every few
seconds when the either refrigerator door has been left open for
3 continuous minutes. The alarm will sound until the door is
closed or Door Alarm is turned off.
1. On the main menu, press the touch pad next to "Options."
2. Press the touch pad next to "Door Alarm Is On" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
Humidity Control (on some models)
The humidity control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments or
when you notice moisture on the door hinge seal. The refrigerator
uses more energy when Humidity Control is on.
1. On the main menu, press the touch pad next to "Options."
2. Press the touch pad next to "Humid Ctrl Is On" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
Vacation Mode
The vacation mode feature decreases the number of automatic
defrost cycles. Once set, vacation mode will remain on until a
door is opened or the feature is turned off on the control panel.
NOTE: Door openings are ignored for the first hour after Vacation
mode is activated.
1. On the main menu, press the touch pad next to "Options."
2. In each of the following screens, continue to press the touch
pad next to "More Options" until "Vac. Mode is Off" appears
on the display.
3. Press the touch pad next to "Vac. Mode is Off" to switch
between ON and OFF. Press the touch pad next to "Done" to
lock in the desired setting and return to the main menu.
ADJUSTMENT:
FRESH FOOD Control
1° lower
FREEZER Control
1° lower
FRESH FOOD Control
1° higher
FREEZER Control
1° higher
9