Epson MX-80F/T Operation Manual page 56

3. Put base plate C on stand A and secure it by inserting two screw grommets
E to the corresponding square holes as shown in Fig. 3. In this case, take
note of the direction in which base plate C must be placed on the stand.
4. Set tension lever F on stand A as follows:
4-1: Hook the tension lever on the nose of stand A as shown in Fig. 4-1.
4-2: While pulling the tension lever up, put the wire into the hole as shown
in Fig. 4-2.
Fig. 4-1
5. Fig. 5 shows the Roll Paper Holder in the assembled state.
Fig. 3 Mounting of Base Plate on Stand
Fig. 5 Assembled Roll Paper Holder
- 5 0 -