Running Basic Switch Operations Using Telnet; Logging Into The Switch - HP StorageWorks 2/16 - SAN Switch Installation Manual

Use these steps to enable a licensed feature.
1. Log in to the switch as the admin user.
2. At the command line enter the following command:
Note:
sensitive.

Running Basic Switch Operations Using Telnet

Read the following sections to run common switch operations.

Logging into the Switch

Use these steps to log into the switch.
1. Open a telnet connection to the switch. The login prompt displays if the telnet
Note:
enable connection through telnet.
2. At the login prompt enter the user ID you are logging in as. For example:
3. Enter the password for the user:
4. If the login was successful, a prompt is displayed showing the switch name
hp StorageWorks SAN Switch 2/16 Installation Guide
licenseAdd aaaBbbCcc
(where aaaBbbCcc is the license key for a particular feature.)
You must enter a license key for each feature to activate. License keys are case
connection successfully found the switch in the network.
The switch must be connected to your IP network through the RS-232 port to
login: admin
The password prompt is displayed if the user exists.
password: xxxxxx
The default password is password.
and user ID you are logged in as. For example:
switch55>admin:
Managing the SAN Switch 2/16
69