Specifying Custom Status Policies; Connecting The Switch To The Fabric - HP StorageWorks 2/16 - SAN Switch Installation Manual

6. Re-enable the switch by entering the following:

Specifying Custom Status Policies

Optional. If desired, specify any custom status policies for the fabric as follows.
1. Enter the following at the prompt.
2. Specify the desired status policies. To completely deactivate the alarm for a
Note:
connecting to the device. The default port configuration is fabric, not private loop. The
switch does not auto-sense topology.

Connecting the Switch to the Fabric

Use these steps to connect the SFPs and cables to switch ports as required.
Note:
For a list of these requirements, refer to the
3.0.x/4.0.x user's guide
1. Remove the shipping plug from the appropriate ports.
2. Position the SFP so that the key (the tab near the cable-end of the SFP) is on
3. Insert the SFP into the port until it is firmly seated and the latching
Note:
the port. If the SFP does not slide in easily, check the orientation.
hp StorageWorks SAN Switch 2/16 Installation Guide
switchEnable
switchStatusPolicySet
particular condition, enter 0 at the prompt for that condition.
Configure each port to match the topology of each host or target before
The ports and cables used in trunking groups must meet specific requirements.
.
top.
mechanism clicks.
The SFP is keyed so that it can only be inserted with the correct orientation into
Installing the SAN Switch 2/16
hp StorageWorks ISL trunking version
55