1. MX-80 F/T Type II Dot Matrix Printer
2. Separator
3. Cartridge Ribbon
4. Power Cord (Only European Type 220/24OV)
5. MX-80 F/T Type I I Operation Manual
3. Installation of the Printer
(1) Operating site selection
When installing the MX-80 F/T Type I I, observe the following instructions.
(a)
Place the Printer on a bench, tabletop or any other convenient flat surface
with enough room for the separator in the back of the Printer. Your
layout may look like Fig. 20.
NOTE: Rubber feet are provided to prevent the marring of the surface on which the
MX-80 F/T Type I I is placed.
(b) Avoid operating the MX-80 F/T Type. I I in places where it may be exposed
to direct sunlight or where a great deal of greasy dust exists in the air.
NOTE: Greasy dust may cause the malfunction of the print head.
(c) Connect the power cord to an outlet separated from those connected to
electric noise-generating equipment, such as large-power motors, refrigera-
tors, etc.
(d) Do not subject the Printer to temperatures below 5°C (40°F) or above
35°C (95°F) during operation, to sudden changes in temperature, or to
extreme shock.
Fig. 19 Contents of Carton
- 1 8 -
1
1
1
1
1