Table of Contents
Advertisement
INSTALLATION OF MX-80 F/T TYPE II
1. Unpacking
Before removing the MX-80 F/T Type II from the carton, check the box for
evidence of shipping damage or mishandling. If such evidence is present, notify the
carrier immediately.
1.1. Unpacking steps
Unpacking steps are as follows:
Open the carton.
STEP 1.
STEP 2. Remove accessories.
Remove the MX-80 F/T Type I I by holding its underside and lifting it
STEP 3.
straight up with the packing material attached.
STEP 4. Place the Printer with the packing material on a table or any other
convenient flat surface.
Take off the packing material carefully.
STEP 5.
Remove the vinyl cover.
STEP 6.
1.2. Repacking steps
Repacking can be carried out by following the above steps in the reverse order.
(Repacking: Shipment for repair, storage, etc.)
NOTE: It is recommended that all original packing materials be saved for reuse in case the
MX-80 F/T Type I I requires reshipment in the future.
2. Counting the Parts
The MX-80 F/T Type I I and standard accessories are as shown in Fig. 19. Upon
unpacking, if you notice any listed contents missing or evident damage, contact the
store where you purchased the MX-80 F/T Type I I as soon as possible.
- 1 7 -
Advertisement
Table of Contents
