Installation Of The Printer; Fig. 3 Laying Printer On Firm Surface - Epson M X - 8 Operation Manual

3. Installation of the Printer

(1) Operating site selection
When installing the MX-80 Type I I, observe the following instructions.
(a) Place the Printer on a bench, tabletop or any other convenient flat surface
with enough room for the separator in the back of the Printer. Your lay-
out may look like Fig. 3.
NOTE: Rubber feet are provided to prevent the marring of the surface on which the
MX-80 Type I I is placed.
(b) Avoid operating the MX-80 Type I I in places where it may be exposed to
direct sunlight or where a great deal of greasy dust exists in the air.
NOTE: Greasy dust may cause the malfunction of the print head.
(c) Connect the power cord to an outlet separated from those connected to
electric noise-generating equipment, such as large-power motors, refrigera-
tors, etc.
(d) Do not subject the Printer to temperatures below 5°C (4O°F) or above
35°C (95°F) during operation, to sudden changes in temperature, or to
extreme shock.
(e) Avoid use of the Printer in humid locations or in the vicinity of heat
generating sources such as heater, etc.
CRT Display

Fig. 3 Laying Printer on Firm Surface