The Cut Sheet Feeder; Installing The Cut Sheet Feeder - Epson LQ-800 User Manual

The cut sheet feeder automatically loads single sheets of paper into
the LQ, allowing you to print on letterhead, bond, or individual
forms.

Installing the Cut Sheet Feeder

1. Make sure the power is OFF.
Set DIP switch 1-8 on the back of the printer to the ON position
2.
and DIP switch
feeder. See Appendix A for information on resetting the DIP
switches.
3. Remove the front cover that came installed on your LQ by tilting it
up and lifting it off the printer. Replace it with the new cover
included with the cut sheet feeder, as shown in Figure
new cover in an upright position so you can see inside the printer.
Also remove the single-sheet guide.
Figure 2-1. Preparing the printer
Chapter 2

The Cut Sheet Feeder

to the OFF position to select the cut sheet
1-7
2-1.
installation
for
Leave the
2-1