Paper Handling - Epson LQ-300+ User Manual

The print position is not what you expected
Printing starts too high or too low on the page, or the bottom part
of one page is printed at the top of the next page.
Cause
Your application software
settings may be incorrect.
Page length does not match the length of the paper.
Cause
The page length setting in
your application may be
incorrect.
The printer's page length
setting for the tractor may not
match the size of the
continuous paper you are
using.
Regular gaps occur in the printout.
Cause
One-inch
skip-over-perforation may be
set.

Paper Handling

Single sheets do not feed properly
Paper does not feed.
94
Troubleshooting
What to do
Check the margin or top-of-form
position setting in your application
software.
What to do
Check the page length set by your
application software and adjust it if
necessary.
Check Page length for tractor if the
printer's default settings. See "About
Your Printer's Default Settings" on page
16.
What to do
Set skip-over-perforation to off in the
Default Setting mode. See "About Your
Printer's Default Settings" on page 16.