Epson LQ-300+ User Manual page 52

7. Take a stack of paper and fan it. Next, tap the side and bottom
of the paper on a flat surface to even up the stack.
c
8. Insert up to 50 sheets of paper along the left paper guide.
9. Adjust the position of the right paper guide so that it matches
your paper's width. Make sure the position of the guide
allows the paper to move up and down freely.
10. Push the paper-set levers back to clamp the paper against the
guide rollers.
11. Remove the paper supports from the edge guides. Insert the
two stacker supports packed with the cut-sheet feeder into the
holes on the edge guides.
12. Attach the paper guide to the cut-sheet feeder as shown
below.
View from above
Release tab
52
Caution:
Do not use envelopes, multipart forms, carbon paper, or labels
in the cut-sheet feeder.
Release tab