Table of Contents
Advertisement
UP349BH (WDECT2300) ENG OM
System Reset
De-register the Handset
1) Enter the System Reset menu, and then the Deregister
HS submenu (see "Entering the Menu" on page 11).
2) Press
.
3) Press
/vol/
or
4) Press
. You will hear a confirmation tone.
When de-registration is complete,
appears.
5) After de-registering the handset, move to "Replacing the
Base Setting" below.
Replacing the Base Setting
1) Enter the System Reset menu, and then the Replacing
Base submenu (see "Entering the Menu" on page 11).
appears.
2) Press
/vol/
or
3) Press
. You will hear a confirmation tone.
The base information will be deleted.
When replacing the base is complete,
appears, register the handset to the new base.
4) Place the handset in the base unit to begin registration.
5) While the handset is registering, "Handset Registering" will appear in the LCD.
When "Registration Complete" is displayed, the handset has been registered to
the base.
If "Registration Failed" appears, please try these steps again.
5/12/04
10:53 AM
Page 15
appears.
/vol/
to select
.
/vol/
to select
.
Make sure to perform
the Replacing Base
after de-register
the handset.
[ 15 ]
Advertisement
Table of Contents
