Placing A Call; Selecting A Channel; Using The Flash Button; Setting The Handset Receiver Volume - Uniden XC 340 Operating Manual

Placing a Call
To place a call with your
XC340:
1.
Remove the Handset from the Base Unit and press
TALK.
2. Dial the number you are calling.
3. When you have finished the call, press TALK or return the Handset onto the
Base Unit.
NOTE: If you don't place the Handset back on the Base Unit, you will need
to press TALK TO HANG UP THE PHONE.
Selecting a Channel
The CHANNEL button on the Handset allows you to choose among ten factory
set channels. If you are receiving any interferenceon a channel, press the button
to switch to another channel. This function works only when the phone is in use.
NOTE:
If you have more than one cordless phone in your house, they must
be set to different channels.
Using
the Flash Button
Use FLASH to send a timed "hook-flash" on the telephone line for accessing
services such as call waiting, etc. To use this function, simply press the
FLASH/A.TONE button while operating
the Handset.
Setting the Handset Receiver Volume
While
on a phone call using the Handset, press the VOLUME/A. VOl button to
select e~her loud or soft earpiece speaker volume.
Setting the Base Unit Receiver Volume
While on a phone call using the Base Unit, slide the Volume Control to adjust the
volume level of the Speaker.
Using
the Redial Button
ADl/P
dials the last number that you have called. This function is extremely
useful when the number you called is busy. To use this function, simply press
AOUP. The last number you called will then be dialed again.
NOTE: If any other key is pressed before ROUP, this function will not work.
17
I