Installing The Inner Cma Attachment Bracket; Routing The Power Cables Through The Strain Reliefs; Routing The Cables Through The Cma; Figure 2: Attaching The Inner Cma Attachment Bracket - Dell PowerEdge Metered Manual

Cable Routing Procedures for Dell™ PowerEdge™ R310 & R410 Systems

1.2 Installing the Inner CMA Attachment Bracket

As described in the Rack Installation Instructions,
attachment bracket based on which side you wish to mount the CMA. Use the bracket marked "A" for
mounting the CMA on the left side, and the bracket marked "B" for mounting on the right side. See
Figure 2.

Figure 2: Attaching the Inner CMA Attachment Bracket

1.3 Routing the Power Cables Through the Strain Reliefs

After you have installed the tray and cables, route the power cables through the strain reliefs located
on the power supply handles as shown in Figure 3.

Figure 3: Routing Power Cables Through the Strain Reliefs

1.4 Routing the Cables Through the CMA

You can install the CMA on either the rear right or rear left side of the rails. Mounting the CMA on the
side that is opposite of the power supplies (left-side mount) is recommended; otherwise, the CMA
must be disconnected, to some extent, in order to remove the power supplies. Refer to Section 3 for
details on power supply replacement.
locate and attach the appropriate inner CMA
Page 3