Brother PE-DESIGN 7.0 Quick Reference Manual page 18

Personal embroidery design software

Hide thumbs Also See for PE-DESIGN 7.0:

Table of Contents

Step 2:

Installing the Driver for the Card Writer Module

This section describes how to install the driver for the card writer

module.

Plug the USB connector into the USB port on

the computer.

Make sure that the connector is fully inserted.

Install the driver for the card writer module.

■

For Windows

installed and connected to the Internet:

XP with Service Pack 2 already

Select Yes, this time only,

and then click Next.

Select Install the software auto-

matically (Recommended), and

then click Next.

Note:

• If you upgrading from version 5.02

or later, skip this section and con-

tinue with the procedure described

in "[STEP 3] Upgrading the USB

card writer module" on page 19.

Memo:

To check whether or not Service

•

Pack 2 is installed, click Start, and

then click on Control Panel, then,

double-click on System to open the

Properties page.

Note:

• Depending on the computer, this

dialog box may not appear. If it

does not appear, skip this step and

continue with the procedure.

Table of Contents