Sony KPR-46EXR15 Operating Instructions Manual page 68

Usingthe Pre-Programmed RemoteCommander
Follow these instructions to set the manufacturer's code,
which will enable you to operate a connected cable
converter box with the pre-programmed Remote
Commander.
Example: Operate a connected Zenith cable converter box.
Remote Commander
(with video control cover open)
MUTING SLEEP POWER
rn EI_
CH+ FREEZETVN1DE0 SWAP PIP
r--] El r--I r--i r--]
CH- POSITIONAUDIO OFF
1221 r--i IZI r-]
®®® °
®@®
®®®
_ r--!
NV WINDOW
PICTURE
r=-i
CH VOL
VTR1-2-3_MDP _BOX
TVNTR CODE SET STANDARD
r-l Q !-7
1
Set the TV/CABLE BOX selector to CABLE BOX.
TV CABLE BOX
While pressing CODE SET, press 6 and 8 (Zenith's
code number-- see Fig. 5) and ENTER.
CODESET
-t-
Usethe projection TV controlbuttons(POWER, 0 - 9,
ENTER and CH +/-) to operatethe cable converter
box.
POWER
@®®
CH
®®®
®®®
®g
To return to the normal screen
Set the W/CABLE BOX selector to TV; then use the
projection -rv control buttons to control the projection "IV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Fig. 8: Cable box manufacturer code numbers
MANUFACTURER CODE
JERROLD 60, 61,62, 63, 64, 65
PIONEER 69, 70
SCIENTIFIC ATLANTA 66, 67
TOCOM 71, 72
ZENITH 68
Notes
• If morethan onecode numberis listed,tryenteringthem one by
one, untilyoucome to the correctcodefor yourequipment.
• If youentera new code number,the code numberyoupreviously
enteredat that settingis erased.
• In some rare cases, yourequipmentmay usea codethat is not
providedwiththisRemoteCommanderand youmay notbe able
to operateyourcable converterboxwiththe suppliedRemote
Commander.In thiscase, usethe equipment's own remote
controlunit.
68 1
Chapter 3: Using Advanced Features