Table of Contents
Advertisement
Connecting OtherEquipment
: Signal flow
(Front inner panel)
to
_
to
video
audio
input
input
(Rear of projection TV)
IN
OUT
VHF/UHF
Q
to
VHF/
UHF _'_r
" ' \ _ _" n_//
,, ,_,.,,_//
to video_
_
_ to audio
Z_
input
_
input
to
VHF/UHF
output
II
VCR, video disc player, etc.
i
I
VMC-810S/820S
_(not_supplied)
_
I
audio/video
output
Preparing
for use
1
Turn on the projection TV.
2
Press TV/VIDEO on the projection TV or on the Remote
Commander so that "VIDEO 1," "VIDEO 2" or "VIDEO 3"
appears on the screen.
VIDEO 1: for equipment connected to VIDEO 1 IN
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
Operating the equipment
Same as p. 15.
To return to TV mode
Press TVNIDEO
or CHANNEL +/- on the projection "IV,
or press TVNIDEO, CH +1- or 0 - 9 and ENTER on the
Remote Commander so that a channel number appears
on the screen.
Notes
• If you try to use equipment that is connect_l to the front and rear
VIDEO 3 IN jacks at the same time, the picture will be distorted.
Be sure you turn off one piece of equipment first.
• If you have connected to a Camcorder's input jacks, do not
connect to the projection TV's input jacks.
• You can label each of the video input modes (p. 53).
• You do not need to select a video mode when you use the direct
play function (pp. 69 - 70).
•
If you connect a monaural VCR, connect the audio output of the
VCR to the L (MONO) jack of VIDEO IN (1, 2 or 3). The monaural
sound will be heard from both speakers.
161
Chapter 1: SettingUp
Advertisement
Table of Contents
