Sony BRAVIA KDL-52XBR5 Operating Instructions Manual page 16

Use tile TV as a monitor for your PC,
Shown below with tile HDI5 to HDI 5 connection, This TV can also be connected to a PC with DVI or
HDMI output, (Refer to the separate Quick Setup Guide.)
Rear of TV
HD15-HD15
cable (analog
RGB)
l Audio cable
(stereo mini plugs) Connect to an HDMI
compatible PC with
an HDMI cable.
• Connect the PC IN jack to the PC using the HDI5-
HDI5 cable with ferrite core (analog RGB, not
supplied) and audio cable (page 121.
• If the PC is connected to the TV and no signal has been
input from the PC l\_r more than 30 seconds, the TV
enters the standby mode antomatically (page 45).
PC Input Signal Reference Chart
After connecting tile PC to tile TV. set tile output signal from tile PC; according to tile chart below.
VGA 640 x 480 31.5 611 VGA
640 x 480 375 75 VESA
720 × 400 31.5 70 VGA-T
SVGA 800 x 600 37.9 6(I VESA Guidelines
8{1{I x 600 46.9 75 VESA
XGA 1024 x 768 48.4 611 VESA Guidelines
1024 x 768 565 70 VESA
1024 x 768 60.0 75 VESA
WXGA 1280 x 768 47.4 ,5(I VESA
1280 x 768 47.8 6(I VESA
1280 x 768 60,3 75
1360 x 768 47.7 6(I VESA
SXGA 1280 x 1024 64.0 6(I VESA
1280 x 1024 811.0 75 VESA
HDTV 1920 x 11180 67.5 6(I
• This TV's PC input does not support Sync on Green or
Composite Sync.
• This TV's PC VGA input does not support interlaced
signals.
• For the best picture
quality, it is recommended to use
the signals (boldfaced) in the above chart with a 60 Hz
vertical frequency from a personal computer. In plug
and play, signals with a 60 Hz vertical frequency will be
detected automatically. (PC reboot may be necessary.)
16