Installing The Tv; Preventing The Tv From Toppling Over; Preparation For Wall-Mounting - Sony BRAVIA KDL-52XBR5 Operating Instructions Manual

1. Installing the TV
TV
stand
Table-Top
Stand
2
1
Screw tile support belt (supplied) to tile TV
stand with a wood screw (supplied).
2
Attach the support belt to the Table-Top Stand
with the securing screw (supplied) using a
coin,
etc.
3 Adjust the length by pulling the support
belt
toward you while holding the Table-Top
Stand.
• Be sure to take measures to prevent the TV from
toppling over and causing injury.
• The supplied wood scre'a, may not be used depending
on the type of TV stand. In this case, or when the
securing strength is not enough, use commercial
screws 1/8
to 3/16
inch (3 to 4 nnn) diameter to fit to the
TV stand. Consult your dealer about the types of
screw(s).
To Replace the Bezel Unit
The bezel unit can be replaced with others that are
sold separately. However. do not remove the unit
except to replace it. For details, see the instructions
supplied with bezel units.
10
This TV can be installed on a wall by using a Wall-
Mount Bracket (sold separately). Before mounting
the TV on a wall, the Table-Top Stand must be
removed fiom the TV.
Follow the simple steps below to remove the
Table-Top Stand:
Disconnect all the cables from the TV.
1
2
Start removing the screws behind the TV (See
illustration below).
Do not remove any other screws from the TV.
3 When screws are removed, lift the TV off the
stand. Make sure that you carry out this task
with at least two or three people. Do not
attempt to lilt the TV by yourseff
• Do not remove the Table-Top Stand for any reason
other than to wall-mount the TV.
• When using an electric screwdriver, set the torque
setting to approximately 2 N.m {20 Kgf.cm}.
• Be sure to store the removed screws and Table-Top
Stand in a safe place until you are ready to reattach the
Table-Top Stand. Keep the screws away from small
children.
• For bracket installation, refer to the supplied Installing
the Wall-Mount Bracket and the instruction guide
provided by the Wall-Mount Bracket model for your
TV. Sufficient expertise is required in installing this
TV. especially to determine the strength of the wall for
withstanding the TV's weight.
• For product protection and safety reasons, Sony
strongly recommends that you use the Wall-Mount
Bracket model designed for your TV and that the
wall-mounting of your TV is performed by a Sony
dealer or licensed contractor.