Rear; Connecting The Tv; Cable System And Vhf/Uhf Antenna System; Hd Cable Box/Hd Satellite Box - Sony BRAVIA KDL-52XBR5 Operating Instructions Manual

3. Connecting the TV
You can enjoy high-definition and standard-
definition digital programming (if available in
your area) along with standard-definition analog
programming.
• This TV is capable of receiving unscrambled digital
programming for both cable (QAM and 8VSB) and
external VHF/UHF antenna (ATSC).
• It is strongly recommended that you connect the
antenna/cable input using the 75-ohm coaxial cable
(not supplied) to receive optimum picture quality. A
300-ohm twin lead cable can be easily affected by
radio frequency interference, resulting in signal
degradation.
Cable or VHF/UHF (or VHF only)
75-ohm coaxial
cable _ _ Rear of TV
VHF/UHF/CABLE input
Use an optional A-B RF switch (not supplied) to
switch between the cable and over-the-air antenna
programming, as indicated below.
A-B RF switch
Cable _ _-_ Rear of TV
Antenna _ _LL_ VHF/UHF/CABLE input
• Be sure to set the Cable setting to On or Off in the
Channel settings t\_r the type of input signal you
choose (see page 40).
You can also enjoy high-definition programming
by subscribing to a high-definition cable service or
a high-definition satellite service. For the best
possible picture, make sure you connect this
equipment to your TV via the HDMI or
component video (with audio) input on the back of
your TV.
Shown with HDMI Connection
Rear of TV
i ' ?_iii!ii_i_i _ I_
HDMI cable
. CATV/Satellite
HD cable box/ |antenna
cable
HD satellite box
@
14