The Remote - Sony STR-DG810 Operating Instructions Manual

Programming the remote
You can program the remote to control non-
Sony components by changing the code. Once
the control signals have been memorized, you
can use those components as part of your
system.
Furthemlore, you can also program the remote
for Sony components that the remote is unable
to controh Note that the remote can only
control components that accept infrared
wireless control signals.
1
Press RM SET UP.
Tile RM SET UP indicator slowly flashes.
2
3
4
Press the input button for the
component you want to control.
For example, it"you are going to control a
CD player, press SA-CD/CD. The RM
SET UP indicator lights up.
Press the numeric buttons to
enter the numeric code (or one
of the codes if more than one
code exists) corresponding to
the component and the maker
of the component you want to
control (except TV).
See the tables on pages 80-84 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit
and the last two digits of the numeric code
correspond to the category and the
maker's code respectively.)
Press ENTER.
Once tile numeric code has been verified,
the RM SET UP indicator slowly flashes
twice and the remote automatically exits
the programming mode.
5 Repeat steps 1 to 4 to control
other components.
Notes
• The indicator turns off while a v:did button is
pressed.
• In step 2, if several input buttons are pressed, only
the last pressed button is wfiid.
• In step 2, if you press TUNER, you can only
program the button to control a tuner (page 841.
• In step 3, if an input button is pressed, the new
input is selected and the programming procedure
returns to the beginning of step 3.
• For the numeric codes, only the last three numbers
entered are valid.
To program the remote to
control a TV
1 Press RM SET UP.
The RM SET UP indicator slowly flashes.
2 Press TV.
3 Press the numeric buttons to enter the
numeric code (or one of the codes if more
than one code exists) for TV. For details, see
page 82.
4 Press ENTER.
Once the numeric code has been verified,
the RM SET UP indicator slowly flashes
twice and the remote automatically exits the
programming mode.
To cancel programming
Press RM SET UP during any step. Tile RM
SET UP indicator flashes 5 times in quick
succession. The remote automatically exits the
programming mode.
To activate the input after
programming
Press the programmed button to acti'<tte tile
input you want.
1-
0
xI
ID
3
o
continued_
79us