Table of Contents
Advertisement
Using the Head Cleaning Utility
Follow these steps to run the Head Cleaning utility:
1. Make sure the printer is turned on but not printing, and both the B black and
A color ink out lights are off. (If an ink out light is flashing, replace the ink
cartridge before continuing.)
2. If you have an application running, access the printer settings dialog box as
described on page 13.
Or click
Stylus COLOR 660
(
Document Defaults
3. Click the
4. On the Utility menu, click the
5. Follow the instructions on the screen to clean the print head. Cleaning takes a
little over a minute, during which the printer makes some noise and the P power
light flashes.
6. When the P power light stops flashing, run a nozzle check to confirm the print
head nozzles are clean and reset the cleaning cycle.
Make sure paper is loaded in the printer and click
Then click
28
If any paper you buy comes with a cleaning sheet, don't use
the cleaning sheet with this printer; it may jam inside the
printer.
, point to
Start
Settings
icon in the Printers windows. Then select
in Windows NT).
tab.
Utility
Never turn off the printer while the P power light is flashing,
unless the printer hasn't moved or made noise for more than
5 minutes.
. The nozzle check pattern prints; see the next section for details.
Next
, then select
Printers
button.
Head Cleaning
Print nozzle check pattern
. Right-click the
EPSON
Properties
.
Advertisement
Table of Contents
