Advertisement
BA'FrERY REPLACEMENT
TheConsole (7) requires two
"LR44" watch
batteries. To replace the batteries, first remove three
of the sorews that attach the Console to the Upright
(10). Loosen the fourth screw. Pivot the Console until
the batteries are visible (see the drawing below).
HOW TO STORE THE TREADMILL
To convert the treadmill to the storage position,
first turn the Arm Resistance.Control
(15) counter-
clockwise until it tums freely (see the drawing
below). Failure to do so will result in damage to
the treadmill.
7_
Remove Screws
Loosen
Using a small screwdriver, push the batteries out of
the Console (7). Be sure to note which way the bat-
terles were turned. Inse_t two new batteries. Re-
attach the Console to the Upright (10).
Note: Watch batteries are sold in the hardware depad-
ment of your nearest SEARS store.
2
24
25
45
Next, remove the Upright Bolt (24) and Upright Flat
Washer (25) from the Upright (10). Lay the Upright and
the Upper Body Arms (1, 2) on the Walking Belt (45).
Be careful not to pinch the sensor wire in the
tJprlghL Replace the Upright Bolt and Upright Flat
WasheHor storage.
TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, call our toll-free HOTUNE at 1-800-
736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
1. SYMPTOM: THE CONSOLE DOES NOT
FUNCTiON PROPERLY
a. Replace the batteries. (See BA'I-FERY REPLACE-
MENT at the top of this page.)
b. The console, like most electronics, is susceptible
to static electricity build-up, caused, by certain
types of clothing or machine operation. If the
console blanks out or gives false readings, an
anti-static spray should be applied to the upper
body arms and the upright, especially the base of
the upright. Anti-static spray is available where
laundry supplies are sold.
c. Carefully tip the treadmill on its left side. Refer to
the drawing at the right and locate the Reed
Switch (29). Turn the Front Roller (27) until the
Magnet (51) is aligned with the Reed Switch.
Loosen the Screw (5). Adjust the Reed Switch so
that there is a 1/8" gap between the Reed Switch
and the Magnet. Retighten the Screw.
5
Underside of Treadmill
7
Advertisement
