3. INSTALLATION
3-12-1. Installing the air unit
Make sure that the air unit does not touch the control box or the work table leg.
3161Q
3162Q
<When installing to the underside of the work table>
1. Remove the two screws (1) and the valve setting plate (2).
2. Turn the valve setting plate (2) upside down, and install it to the underside of the work table using the two wood screws (3) and
washers (4) which are provided as accessories.
* At this time, install the valve setting plate (2) in a position where it will not be in the way when using the machine. (The
recommended installation position is shown in Figure 1.)
3. Install the ground cord (5) to the machine head.
4. Install the air unit (6) to the valve setting plate (2) with two screws (1).
5. Connect the air hose (7).
6. Adjust the air pressure. (Refer to "10-10. Adjusting the air pressure".)
<When installing to a beam>
1. Make holes in the beam as shown in the illustration above. (Button hole diameter is 5.4 mm. The pitch is 50 mm.)
2. Install the air unit (8) to the beam with two accessory screws (9) and two bolts (10).
3. Install the ground cord (11) to the machine head.
4. Connect the air hose (12).
5. Adjust the air pressure. (Refer to "10-10. Adjusting the air pressure".)
13
KE-484C
1093Q
Fig. 1
2598Q