Setting The Work Clamp Mode - Brother KE-484C Instruction Manual

14. SETTING THE WORK CLAMP MODE

Through the combination of DIP switches A-1 and A-2 on the operation panel, presser motions can be set as follows:
When memo-42 = 0 (initial value)
DIPA-1 DIPA-2
−
ON
ON ON
−
ON
Special memo-42 settings
memo-42 Pedal specifications
5 Two pedals
6 Two pedals
7 Two pedals
Three pedals
8
(Option)
9 Two pedals
10 Two pedals
Three pedals
11
(Option)
Three pedals
12
(Option)
13 Two pedals
When memo-42 has been used to make a special setting, DIP switches A-1 and A-2 function as follows.
• When DIP switch A-1 is at ON, the pressers are not raised automatically at the sewing end.
• DIP switch A-2 is ignored except when memo-42 = 8.
Pedal specifications
Single pedal
Single pedal
−
Two pedals
−
Two pedals
Left presser drops when presser pedal is at the 1st step, and right presser drops
when presser pedal is at the 2nd step.
Raising is carried out in the reverse order.
* Setting used when using the light work clamp function (Refer to "14-1. Light work
clamp".)
Right presser drops when presser pedal is at the 1st step, and left presser drops
when presser pedal is at the 2nd step.
Raising is carried out in the reverse order.
The left/right operating sequence changes alternately for each item sewn when
using two-pedal operation.
Starts with right → left.
The left pedal is used to raise and lower the left presser, and the right (center) pedal
is used to raise and lower the right presser.
The start (right) pedal is used to start sewing.
Furthermore, when DIP switch A-2 is at ON, and if one presser is already lowered,
pressing the start pedal causes the other presser to be lowered and then sewing
starts.
When the presser pedal is depressed to the 1st step, both left and right pressers are
raised simultaneously.
When it is pressed to the 2nd step, sewing starts.
When the start pedal is depressed, both left and right pressers are lowered
simultaneously.
When the start pedal is released, sewing starts.
The left pedal raises and lowers the left and right work clamps, and the right pedal
(center) detects the home position.
The start (right) pedal is used to start sewing.
The left pedal raises and lowers the left work clamp, and the right pedal (center)
detects the home position.
When the start pedal (right side) is depressed for a short time (200 ms), the right
work clamp is lowered, and when it is depressed for a longer time the right work
clamp is lowered and then sewing starts.
Two-pedal operation raises and lowers the left and right work clamps
simultaneously.
14. SETTING THE WORK CLAMP MODE
Raising the presser at the sewing end
Presser is raised automatically.
Presser is raised by pressing the pedal.
Presser is raised automatically, then it is lowered by pressing
the pedal. (factory default settings)
Presser is kept lifted while the presser pedal is pressed.
Raising the presser at the sewing end
KE-484C 54