Fanfold Displacement - Epson C I - 4 0 4 User Manual

This parameter covers a range of - / to + / of an inch (0.42 mm),
where "-" is up the page and "+" is further down the page (see also the
table in Chapter 3.4 Configuring the Printer for VERT.POS.ADJ.).
The set up of VERT.POS.ADJ. will become effective at the next page of
Note:
the form. Therefore, it is recommended to perform VERT.POS.ADJ. set up
as long as the paper is in the park position and before starting the print job.
- Fanfold Displacement (FANFOLD DIS)
A continuous form can manually be displaced by this function when it is
either correctly loaded at the park position or already fed and partly printed.
The Fanfold Displacement mode can only be called up in the status
READY or BUSY.
The key
Note:
As soon as the Fanfold Displacement mode is entered by pressing
the printer stops printing and changes into the LOCAL mode. The display
shows the message FANFOLD DIS with the value 0. By pressing
or (92) a vertical displacement is possible.
Key
1
2
3
4
5
This parameter influences the line counter of the current print job and
Note:
cannot be saved. A form feed (FF) sent by the application to the printer
cancels all these settings.
has no effect when in the READY or BUSY mode.
Display
READY
FANFOLD DIS
FANFOLD DIS
FANFOLD DIS
READY
15 240
60 60
(91)
1 ELQ
0
0, +1, +2, +3...
....+3, +2,+ 1, 0
1 ELQ
Printer Operation
,
(91)
2-5