Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons.
Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. Assembly
requires
the includ-
ed tools and your own adjustable
wrench _,
Phillips
screwdriver
_
_,
and
pliers
_.
Use the drawings below to identify the small parts used for assembly. The number in parentheses
below each
drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been preassembled.
If a part is not in
the parts bag, check to see if it has been preassembled.
M4 x 25mm Round
Head Screw (41)-3
M8 Split
M8 Nylon
Washer (42)-7
Locknut (10)-4
M6 x 15mm Button
M8 x 15mm Sutton
Screw (46)-4
Screw (34)-3
M8 x 60mm Button
Screw (30)-4
M8 x 73mm Sutton
Screw (33)-2
1. Insert the Rear Stabilizer (6) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 60mm
Button Screws (30).
2. Orient the Front Stabilizer (2) with the large holes
facing the Frame (1). Attach the Front Stabilizer to
the Frame with two M8 x 73mm Button Screws (33).
30
33
Large
Holes
1
Hide quick links:
Advertisement
Table of Contents
