Data Communications Between a PV Unit and
a BN Unit
This section describes how to set up and communicate between a PV Unit and a
BN Unit (BN-10/BN-20 or BN-10A/BN-20A/BN-40A).
To connect a PV Unit to a BN Unit
1. Make sure that the power of both units is turned off.
2. Open the cover of the Mini Cradle port of the BN Unit, and connect its
Mini Cradle to the port.
3. Place the PV Unit onto its cradle.
•
Gently but firmly press down on the PV Unit to ensure that it is inserted
into the cradle as far as it will go.
4. Use an optional SB-90 9-9 pin connector to connect the PV Unit cradle
to the BN Unit Mini Cradle.
Host unit (PV Unit)
•
All data communication settings must be made on the PV Unit, which is
the host unit. The BN Unit is the terminal unit.
140
Terminal unit (BN Unit)
Cradle
Mini Cradle
SB-90 9-9 pin connector
START button