Installing Status Monitor 2 - Epson Stylus Color 850N User Manual

Using Floppy Diskettes
Note:
You may not see screens
for all the steps here,
depending on your
computer's configuration.
If you are using Windows
95 on a peer-to-peer
network, make sure you
have TCP/IP installed on
your system before

installing Status Monitor 2

so you can enable EPSON
TCP/IP printing.
Write down your settings
in the spaces provided as
you install the first part of
Status Monitor 2. You
need to select the same
settings for the second
part.
Installing Status Monitor 2
EPSON Status Monitor 2 is a single utility that you install on
your computer in two parts. For each system that will monitor
the printer, make sure you install the network part and the
EPSON Stylus COLOR 850 part of EPSON Status Monitor 2.
Follow these steps to install EPSON Status Monitor 2:
1. Insert Status Monitor 2 for Network, diskette 1 in your
drive.
2. Click , then click
Start
3. Type and click
A:\SETUP
4. Close any open programs and click
asking where you want to install Status Monitor 2.
5. Click to accept the default directory or choose a
Next
different directory and click
6. If you are using Windows 95 and you have TCP/IP
installed, you see a screen asking you if you want to enable
EPSON TCP/IP printing. Select
with TCP/IP, and then click
Novell NetWare, select
TCP/IP Printing:
7. Select the type of printer(s) you want to monitor and click
.
Next
Monitor:
EPSON TCP/IP printers_______ NetWare
printers_______ local printers_______
8. Select to monitor EPSON network printers that
Monitor
do not have drivers installed in your computer. Select
if network traffic is a problem. Then click
not monitor
.
Next
Printers: Monitor_______ Do not monitor_______
A-6
.
Run
.
OK
. A screen appears
Next
.
Next
if you want to print
Yes
. If you are printing with
Next
.
No
Yes_______ No_______
Do