Table of Contents
Advertisement
59
3
Progress Bar – This bar displays the percentage complete when performing an Object Search.
4
Cancel – Selecting the Cancel button exits the Object Search.
5
Stop – The Stop option stops the current search.
6
Apply to Main Search – Apply to Main Search exits the Object Search but takes the selected result (the
current image displayed) and displays it inside the Main Search. From that point you can use the Play Controls.
7
Reload First Frame – This option reloads the initial Key Frame image, that is, the image used to start the
search.
8
Clear Selection – This option clears the current Motion Region Box from the Keyframe Image.
9
Start Search – This option Begins the search.
Motion Region Box – The Motion Region Box is the user defined area of the Keyframe image. You create the
10
Motion Region Box by clicking inside the image and dragging the mouse. The Motion Region Box can be
resized by pulling on the little square boxes located on the outer perimeter of the Box.
1
2
3
4
Figure 5.10b
1
Start – This displays the time and date of the initial Key Frame.
Sensitivity – The Sensitivity option allows you to control sensitivity of the motion that will be detected. Often
2
times poor lighting conditions can be interpreted as motion. The sensitivity can compensate for this.
3
Key Frame Search – Selecting the Cancel button exits the Object Search.
4
Show Detected Image – This option, when selected, displays the results as it finds them. Using this option
slows the search process slightly and therefore may not be ideal when searching large periods of time.
End – This option allows you designate an end time. The default is one hour.
5
Performing an Object Search
1)
Begin by selecting a single camera. You can do this either by turning off all cameras but one, or by double clicking
a displayed image (it will then be the only image displayed on the screen)
5
Figure 5.10b
Advertisement
Table of Contents
