Applicable Controls - Carrier RAV-SP180UT-UL Installation Manual

4-way Air Discharge Cassette Type
8

APPLICABLE CONTROLS

REQUIREMENT
• When you use this air conditioner for the first time,
it takes approx. 5 minutes until the remote control
becomes available after power-on. This is normal.
<When power is turned on for the first time after
installation>
It takes approx. 5 minutes until the remote control
becomes available.
Power "SETTING" "SETTING"
on flashes goes out
<When power is turned on for the second (or
later) time>
It takes approx. 1 minute until the remote control
becomes available.
"SETTING" "SETTING"
Power
flashes goes out
on
• Normal settings were made as factory default.
Change the indoor unit settings as required.
• Use the wired remote control to change the
settings.
* The settings cannot be changed using the
wireless remote control, sub remote control,
or remote-controlless system (for central
remote control only). Therefore, install the
wired remote control to change the settings.
Approx. 5 minutes
Remote
control is
available
Approx. 1 minutes
Remote
control is
available
Changing applicable control
setting
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings.)
4
6
1 5
1
Procedure
Push button and temp. setup
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
the display content, and repeat the procedure from
the beginning.
(No operation of the remote control is accepted for a
while after button is pushed.)
(* Display content varies with
the indoor unit model.)
2
Procedure
Each time you push
numbers in the control group change cyclically. Select
the indoor unit you want to change settings for.
The fan of the selected unit runs and the louvers start
swinging. You can confirm the indoor unit for which you
want to change settings.
– 22 –
Installation Manual
1
3
2
button
button to erase
button, indoor unit
EN
22-EN