Craftsman 113.290650 Owner's Manual page 45

f
©
CALIBRATION GAUGE
Use to set calibration point in elevation for
cutting tools 10" or smaller, such as DADO
or MOLDING HEAD.
THIS LINE EVEN WITH TABLE TOP
DIRECTIONS
1. Unplug saw; remove cutting tool.
2. Assemble new Cutting tool per
instructions with cutting tool and
tighten arbor nut.
3, Install proper insert.
4. Plug saw in, turn MASTER switch on and
press _
key.
5. Place the notch of this card to the left
side of cutting tool, over the fixed blade
collar.
6.
7.
Hold this gauge on the blade collar while
pressing the _ or _ key,
until the heavy line is even with the table
top.
Press _ key.
PLACE OVER LEFT BLADE COLLAR
45