Bladeguard; Table Insert - Craftsman 113.290650 Owner's Manual

8_,BLADEGUARD must always be in place and
working properly for all thru-sawing cuts That
fs, all cuts where ,the blade cuts completely
through the workpiece.
THUMBSCREW
\
\
To remove the guard for special operations,
loosen the thumbscrew and slide the guard off
of the rod. DO NOT DISTURB THE SETTING
OF THE ROD.
When replacing the guard, make sure the PIN m
the rod engages with the NOTCH in the
spreader support. Make sure thumbscrew is
tightened securely.
9. TABLE INSERT is removable for removing or
installing blades or other cutt ng tools.
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE
REMOVING INSERT
A. Use "Shut Down Procedure" Page 30, to
retain calibration.
B. Raise blade guard.
C. Loosen Screw.
D. Lift insert from front end. and pull toward
front of saw.
NEVER OPERATE THE SAW WITHOUT THE
PROPER INSERT IN PLACE. USE THE SAW
BLADE INSERT WHEN SAWING . . . USE THE
COMBINATION DADO-MOLDING INSERT
WHEN DADOING OR MOLDING.
10. REMOVING AND INSTALLING SAWBLADE
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE
REMOVING OR INSTALLING SAWBLADE.
NOTE: If blade is above table when plug is
removed from power source, it will be necessary
to recalibrate the electronic function. See page
28.
A. Raise Blade Guard .. remove insert.
B. To REMOVE blade, place a block of wood
against front of blade... PULL arbor wrench
toward you to LOOSEN arbor nut.
WOOD BLOCK
/
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
C. To TIGHTEN arbor nut, place a block of wood
against rear of blade .. PUSH wrench away
from you.
When installing the blade.., make sure the
teeth are pointing toward the front of the
saw.., and that the b ade and collars are clean,
and free from any burrs.
The HOLLOW side of the collar must be against
the blade.
Always tighten the arbor nut securely.
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
BLOCK
BOR NUT
LOOSE
ARBOR COLLAR
T,,T, PO'NT,NG T
FRONT OF SA_,f "_, / _(_
26