Using Featherboards; Recommended Accessories - Craftsman 113.290650 Owner's Manual

USING FEATHERBOARDS
Add 8 inch high flat facing board to the fence, the
full length of the fence.
Use featherboards for all non "thru-sawing"
operations (when sawblade guard must be
removed). Featherboards are used to keep the work
in contact with the fence and the table as shown,
and to stop kickbacks.
Mount featherboards to fence and table as shown,
so that leading edges of featherboards will support
workpiece until cut is complete, and the workp_ece
has been pushed completely past the cutter
/
/
_BOARD
"C" CLAMPS
WORK SUPPORT
(sawblade, dado head, molding head, etc.) with a
pushstick, as in ripping.
Before starting the operation (switch 'OFF' and
cutter below table surface}:
(a) Install featherboards so they exert pressure on
the workpiece; be positive they are secure, and
(b) Make sure by trial that the featherboards will
stop a kickback if one should occur.
Featherboards are not employed during non thru-
sawing operations when using the miter gauge
Replace the sawblade guard as soon as the non
thru-sawing operation is complete.
/
/
RECOMMENDED ACCESSORIES
ITEM CAT. NO.
Steel Legs ............................ 9-22235
_t_gl _tand ........................... 9-22214
Caster Sets ................. 9-22222 or 9-22221
Solid Table Extension ................. 9-29957
7 in. Molding Head Set .................. 9-3217
7 in. Molding Head Set .................. 9-3218
7 in. Molding Head ..................... 9-3214
Molding/Dado Insert for 7 in.
Dia. Molding or Dado Head ............ 9-29997
Work Light ............................. 9-2480
Work Light ............................. 9-2481
7 in. Dia. Adjustable Dado Head
9-3261 -- 9-3262 -- 9-3263
ITEM CAT. NO.
7 in. Dia. Dado Head .................... 9-3257
Sanding Wheel ....................... 9-22723
Miter-Gauge Stop Rods ............... 9-29924
Miter-Gauge Hold-Down Clamp ....... 9-29928
Taper Jig ............................... 9-3233
Universal Jig ........................... 9-3235
Power Tool Know HOW Handbook
Table Saw ............................ 9-2918
Sawdust Collector .................... 9-29966
Rip Fence Bar ........................ 9-29969
Table Extension ...................... 9-29968
10" Dia. Sawblades with 5/8 bore ... see Catalog
4O