Craftsman 113.290650 Owner's Manual page 37

Feedthe workpiece by handalongthe AUXILIARY
FENCE untilthe end is approx.1 in. pastthefront
edgeofthe table.Continue tofeedusingthe PUSH
BLOCK.
Holdtheworkpiece in positionandinstallthePUSH
BLOCKby sliding it on top of the AUXILIARY
FENCE/WORK SUPPORT (ThisMayRaise Guard).
Narrow stripsthickerthantheAuxiliaryFence/Work
Supportmayenterthe guardandstrikethe baffle.
CAREFULLY raiseguardonlyenoughto clearthe
workpiece. U sePUSHBLOCKto complete cut.
BAFFLE
In this example a 14" wide board will be cut down the
center.
Have saw calibrated. Have guard in position.
STEP 1- Position the board so the usuable piece
will be 7 inches between the blade and the
fence.
STEP 2- Adjust the fence against the board so it is
parallel to the saw blade. Lock the fence in
position,
STEP 3-
STEP 4-
STEP 5-
STEP 6-
STEP 7-
Turn MASTER switch "ON" and press
• _ key. Press number keys _
_-_ (decimal equivalent of 7/8
inches.) Press [_ key. The blade will
automatically raise to the programmed
height. Blade elevation will be displayed.
Firmly hold the board in cutting position.
Turn on the saw motor.
Guide the board through the blade,
Pushing only on the piece between blade
and the fence.
Turn the motor "OFF". Wait for the blade
to _top before removing the boards.
Press _ key. Press number key
[_ , Press _ key. The blade will
lower automatically until it is even with the
table.
WORKPIECE
37