Lvm-Maintenance Mode Hp-Ux Booting - HP rp7440 Service Manual

Main Menu: Enter command or menu > BOOT 0/0/2/0/0.13
BCH Directed Boot Path: 0/0/2/0/0.13
Do you wish to stop at the ISL prompt prior to booting? (y/n) >> y
Initializing boot Device.
....
ISL Revision A.00.42
ISL>
3. From the ISL prompt, issue the appropriate Secondary System Loader (hpux) command to
boot the HP-UX kernel in the desired mode.
Use the hpux loader to specify the boot mode options and to specify which kernel to boot
on the nPartition (for example, /stand/vmunix).
• To boot HP-UX in single-user mode:
ISL> hpux -is boot /stand/vmunix
Example 7-1 (page 181)
• To boot HP-UX at the default run level:
ISL> hpux boot /stand/vmunix
To exit the ISL prompt and return to the BCH interface, issue the EXIT command instead
of specifying one of the hpux loader commands.
Refer to the hpux(1M) manpage for a detailed list of hpux loader options.
Example 7-1 Single-User HP-UX Boot
ISL Revision A.00.42
ISL> hpux -is /stand/vmunix
Boot
: disk(0/0/2/0/0.13.0.0.0.0.0;0)/stand/vmunix
8241152 + 1736704 + 1402336 start 0x21a0e8
....
INIT: Overriding default level with level
INIT: SINGLE USER MODE
INIT: Running /sbin/sh
#
4. Exit the console and management processor interfaces if you are finished using them.
To exit the BCH environment, press ^B (Control+B); this exits the nPartition console and
returns to the management processor Main Menu. To exit the management processor, enter
X at the Main Menu.

LVM-Maintenance Mode HP-UX Booting

This section describes how to boot HP-UX in LVM-maintenance mode on cell-based HP 9000
servers.
JUN 19, 1999
shows output from this command.
JUN 19, 1999
HP-UX for the HP Integrity rx7640 and HP 9000 rp7440 Servers
s
181