Lexmark T620 Service Manual page 170

4069-5XX/7XX
Tests
Base Sensor Test
If selected, the following menu selections are
available:
1.Toner
2.Input
3.Output
4.Narrow Media
5.Front Door
Device Tests (only displayed if flash or
disk option is installed)
If selected, the following menu selections are
available:
1.Quick Disk Test (Disk option when
installed)
2.Disk Test/Clean (Disk option when
installed)
3.Flash Test (for flash when installed)
Printer Setup
If selected, the following menu selections are
available:
1.Defaults
2.Page Count
3.Permanent Page Count (viewing)
4.Serial Number (printer serial number)
5.Envelope Enhance
6.Engine Setting 1
7.Engine Setting 2
8.Engine Setting 3
9.Engine Setting 4
10.Configuration ID
11.Edge to Edge
12.Parallel S Strobe Adjustment (only
displayed if printer is configured with
standard parallel port)
13.Par 1 Strobe Adjustment (only displayed if
a parallel port available via PCl slot 1)
14.Par 2 Strobe Adjustment (only displayed if
a parallel port available via PCl slot 2)
3-4
Service Manual
Refer to Test Page
"Base Sensor Test" on
page 3-26
"Device Tests" on
page 3-6
"Printer Setup" on
page 3-30