Software Installation; Tvp5158Evm Software Setup Wizard; Jumper Settings For A Cascaded Tvp5158Evm - Texas Instruments TVP5158 User Manual

Software Installation

Jumper
Designator
W2, W1, W0 TVP5158 I2C address selection
W3, W4 I2C master selection
W7, W8 I2C connection to audio DAC
W9 I2S selection to audio DAC
6 Software Installation
If the TVP5158EVM Software has previously been installed on the PC, it is necessary to uninstall the
previous version. To uninstall:
1. Click Start > Control Panel > Add or Remove Programs.
2. Wait for the list to populate.
3. Scroll down and click on "TVP5158EVM Software" to highlight it.
4. Click the remove button.
5. When prompted with Are you sure you want to remove TVP5158EVM Software from your computer?,
click Yes.
The TVP5158EVM software installation program is contained in a ZIP archive file containing the following
two files:
Setup.exe
TVP5158EVM_Software.msi
Unzip these two files to a temporary directory and run setup.exe. The dialog box in
Click Next on the dialog boxes shown in
the dialog box shown in
Documentation and a shortcut to the VCC application can now be found in the Windows start menu at:
Start > All Programs > TVP5158EVM > TVP5158EVM Software
Start > All Programs > TVP5158EVM > TVP5158EVM User Guide
14
TVP5158 Evaluation Module
Table 6. Jumper Settings for a Cascaded TVP5158EVM
Function
1-2, 1-2, 2-3
OFF, OFF
OFF, OFF
Figure 4,
Figure 7 appears. Click Close to complete the installation.
Figure 4. TVP5158EVM Software Setup Wizard
Copyright © 2009, Texas Instruments Incorporated
Setting
Slave address 0xB2 (1011 LLH0)
Stage 1 TVP5158EVM controls TVP5158 I2C
Disconnected
2-3 Not used
Figure 5, and Figure 6. When the installation is finished,
www.ti.com
Comment
Figure 4 appears.
SLEU108 – November 2009
Submit Documentation Feedback