SPMU357B – August 2013 – Revised March 2014 DK-TM4C123G Overview The Tiva TM4C123G development kit is an evaluation platform for the Tiva TM4C123GH6PGE ARM® Cortex™-M4-based series microcontrollers. The development board highlights the TM4C123GH6PGE microcontroller's USB 2.0 On-The-Go/Host/Device (OTG/Host/Device) interface, 12-bit Analog-to-Digital Converter (ADC), Real-Time Clock (RTC), and battery-backed Hibernation module.
– TivaWare™ for C Series Peripheral Driver Library and example source code – A supported evaluation version of all of the following: • Texas Instruments’ Code Composer Studio™ IDE • Keil™ RealView® Microcontroller Development Kit (MDK-ARM) • IAR Embedded Workbench® development tools •...
In USB Host mode, the development board can provide power to the OTG connector. The USB0EPEN signal controls the Channel 2 Enable (EN2) of a Texas Instruments’ TPS2052B Load Switch (U7), which enables power to the connector's VBUS pin. The POWER SELECT jumper must be in the “ICDI” position.
Data Logger, Motion Sensor, Temperature Sensors, CAN Transceiver, OLED, and SD Card (Schematic page 2) www.ti.com 2.2.4 Temperature Sensors Temperature can be measured by the Texas Instruments TMP20 Analog Temperature Sensor (U3) and/or the internal microcontroller temperature sensor. 2.2.4.1 External TMP20 Temperature Sensor The output of the sensor is connected directly to the microcontroller’s ADC.
The output of a Texas Instruments INA198 Current Shunt Amplifier (U15) is connected to the ADC on the microcontroller. This amplifier increases the voltage drop on a 0.1-Ohm current shunt resistor in line with the V source for the microcontroller.
To achieve the lowest power consumption while in Hibernate mode, the HIB signal is connected to the Channel 1 Enable (EN1) signal of the Texas Instruments TPS2052B load switch (U7). In Hibernate mode, the HIB signal is asserted and the load switch cuts main power to the entire board, excluding the on-board ICDI.
The DK-TM4C123G has additional circuitry that allows the development board to be turned on when a battery is not present or when the battery voltage is too low. A Texas Instruments TPS3803-01 Voltage Detector (U12) monitors V and produces a VBAT_GOOD signal when the battery voltage is above 2.1 V.
Sourcery Codebench • Generic GNU C Compiler • Texas Instruments' Code Composer Studio™ IDE Download evaluation versions of these tools from the Tools & Software section of www.ti.com/tiva. Due to code size restrictions, the evaluation tools may not build all example programs. A full license is necessary to re-build or debug all examples.
PB0/USB0ID USB0DP PL6/USB0DP USB0DM PL7/USB0DM PP0/AIN23_MCU_ISENSE DIO-1N4448HWS TM4C123GH6PGE WAKE DESIGNER REVISION DATE TEXAS INSTRUMENTS 7/9/2013 Tiva™ MICROCONTROLLERS PROJECT TM4C123G Development Kit 108 WILD BASIN ROAD, SUITE 350 AUSTIN TX, 78746 DESCRIPTION www.ti.com/tiva-c Microcontroller, USB OTG, User Switches and LED FILENAME PART NO.
Page 27
SN65HVD1050 MPU-9150 OLED_RGB_CFAL9664B-F-B1 CAN bus termination should be inserted into the scr ew terminals. 0.1UF 0.01UF DESIGNER REVISION DATE TEXAS INSTRUMENTS Tem perature Sensor 7/9/2013 Tiva™ MICROCONTROLLERS PROJECT +3.3V 108 WILD BASIN ROAD, SUITE 350 TM4C123G Development Kit VOUT PE7/AIN20_TEMP AUSTIN TX, 78746 0.1UF...
Page 32
ADDITIONAL TERMS AND CONDITIONS, WARNINGS, RESTRICTIONS, AND DISCLAIMERS FOR EVALUATION MODULES Texas Instruments Incorporated (TI) markets, sells, and loans all evaluation boards, kits, and/or modules (EVMs) pursuant to, and user expressly acknowledges, represents, and agrees, and takes sole responsibility and risk with respect to, the following: 1.
Page 33
RADIO FREQUENCY REGULATORY COMPLIANCE INFORMATION FOR EVALUATION MODULES Texas Instruments Incorporated (TI) evaluation boards, kits, and/or modules (EVMs) and/or accompanying hardware that is marketed, sold, or loaned to users may or may not be subject to radio frequency regulations in specific countries.
Page 35
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.