Parameter Descriptions; Set Parameter Defaults; Host Interface Code; Code Types - Symbol LS 3603 Product Reference Manual

LS 3603 Product Reference Guide

Parameter Descriptions

• Set Parameter Defaults

Scanning the SET ALL DEFAULTS bar code on
to the values listed in the Default Table. (See

• Host Interface Code

Scan the bar code corresponding to your host type. You must select a host type
when you first set up the scanner and whenever you change host types.

• Code Types

The bar code menu selections enable the scanner to decode any or all of the
following symbologies.
UPC Versions A and E (EAN 8 and 13)
•
Codabar
•
Code 39
•
Code 39 Full ASCII
•
Discrete 2 of 5
•
Interleaved 2 of 5
•
Code 128
•
MSI Plessey
•
EAN 128
•
Code 93
•
The scanner will autodiscriminate between all of the above symbologies,
except for Code 39 and Code 39 Full ASCII.

• Code Lengths

Select one or two lengths for the Interleaved or Discrete 2 of 5 codes. Determine
the number of characters represented in the Discrete 2 of 5 or Interleaved 2 of
5 bar codes by counting the number of printed (i.e., human readable) digits
beneath the bar code. Set one or both lengths, one per scanning sequence. For
D 2 of 5, LENGTH 1 may range from 02-55 and LENGTH 2 from 00-55. For
I 2 of 5, LENGTH 1 may range from 02-54 and LENGTH 2 from 00-54.
2-4
page 3-3 returns all parameters
page 2-29.)