Power Mode; Scanstand/Intellistand Time-Out; Wand Emulator Options; Wand Emulator Bar Output - Symbol LS 3603 Product Reference Manual

Hide thumbs Also See for LS 3603:

Table of Contents

LS 3603 Product Reference Guide

• Power Mode

This parameter determines whether or not power remains on after a decode

attempt. When in low power mode, the scanner powers down after each

decode attempt. When in continuous power mode, power remains on after

each decode attempt. To ensure the integrity and proper operation of this

product, it is recommended that the low power mode be set for RS-232C and

Wand modes, and continuous power mode for Synapse mode.

Scanstand/IntelliStand operation can be programmed to shut down if no bar

code is detected within the specified time. Duration is programmable in 15

minute increments from 15 minutes to 90 minutes.

The polarity of the wand emulator output is set automatically when the

Wand Host type is selected. This parameter can be used to change the default

polarity setting to match the type of signal (bar = logic high, or bar = logic

low) expected by the receiving system

This parameter allows the selection of a variable leading margin, ranging from

80 msec to 200 msec, in 10 msec increments.

This parameter converts the output of all data to Code 39 format. Any coded

character not in the Code 39 character set is replaced by a Code 39 blank.

2-16

Table of Contents