Superior UVF-36 Installation And Operating Instructions Manual page 14

Model UVFRC-4228 Shown
Firebox
fl oor
Loose knot in power
cord to take up slack
Figure 22
Model UVFRC-4228
Cabinet Base
Figure 23 -
UVFRC-4228 Shown
Bend Locating Tabs Over
Figure 24 -
UVFRC-4228 Shown
Step 6. Route a 3-wire, 120 VAC, 60 Hz, 1 ph power supply to the right
side of appliance.
Step 7. Locate the J-Box cover (provided in J-Box Kit). Remove the round
knock-out (see Figure 19).
14
Locating Tabs
(into notches)
NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.
Step 8. Ensure that power supply wires are NOT "live" before making
these connections). Install J-Box Cover Plate as follows:
Feed the * Romex wires (or other equivalent plastic insulated wire
- Refer ANSI/NFPA 70 - National Electrical Code - Latest Edition)
through the J-Box Cover retangular opening, then connect to the
J-box wires. The strain relief bushing should be pressed into the
knock-out on J-box cover around the Romex (this will provide
protection to the wires and prevents strain against connections
from J-box). See Wiring Diagram - Figure 16. Install the cover
plate over J-Box opening on appliance as shown in Figure 25.
Note: Wire connections should be positioned inside of the ap-
pliance.
* Romex is a plastic insulated wire from power supply - sometimes called
non-metallic sheath.
Right Side Panel of Firebox
Use screw provided and
secure in place as shown
Screw
Figure 25 -
Installing J-box Cover Plate - All Models
Step 9. Follow the instructions below for the kit you are installing:
FBK-100 Kits - Install a fi eld-provided (or P/N 85L87) ON/OFF wall
switch in a convenient location on a wall, near the fi replace.
FBK-200 Kits - Install the kit-provided variable speed control (rheo-
stat) in a convenient location on a wall, near the fi replace.
Step 10. Follow the instructions below for the model you are installing:
Model UVF-36:
Reinstall the blower access panel that was removed on Step 1 (see
Figure 18).
Models UVFRC-3628, UVFRC-3628-H, UVFRC-4228 & UVFRC-4228-H:
Reinstall the bottom refractory panel that was removed on Step 1
(see Figure 17).
J-Box opening
on appliance
The notched side of
cover plates goes inside
fi rebox panel
Cover Plate