Flash Test; Setting The Page Count; Viewing The Permanent Page Count; Viewing The Error Log - Lexmark Optra SC 1275 Service Manual

Flash Test

This test causes the file system to write and read data on the flash to
test the flash device. The test destroys all data on the flash which is
reformatted at the end of the test.

Setting the Page Count

Use this menu to reset the page count whenever you replace the
engine card. The engine card contains the printer's NVRAM mem-
ory. When you select Page Count from the PRINTER SETUP menu,
the current page count displays as follows:
Page Count
=1234567*
The left-most digit (1 in this example) blinks, indicating it is the first
digit to be changed. To change the value press Menu> or Menu< to
get the value you want. Press Select to move to the next digit. To
skip a digit (keep its current value) press Select.
Press Select after the final digit to store the new page count in
NVRAM.

Viewing the Permanent Page Count

The permanent page count setting cannot be changed through the
control panel. It can only be viewed with the diagnostics menu.
When you select Permanent Page Count the following screen dis-
plays:
Perm Page Count
=1234567*

Viewing the Error Log

The error log provides a history of printer errors. It contains the 12
most recent errors that have occurred in the printer. The most recent
error displays in position 1, and the oldest error displays in position
12 (assuming 12 or more errors have occurred). If fewer than 12
errors have occurred, the oldest error displays in the position before
the empty log entries begin. Empty log entries are identified with the
2-58