Switch cover
Description
Switch cover (includes LED board and cable)
Before removing the switch cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the keyboard (see
Remove the switch cover and keyboard:
1.
Release the ZIF connector to which the LED board cable (1) is attached, and disconnect the LED
board cable from the system board.
2.
Lift the left and right sides of the switch cover (2) until it detaches from the computer.
3.
Release the switch cover (3) as far as the power button board cable allows.
4.
Disconnect the power button board cable (4) from the system board.
5.
Remove the switch cover.
Reverse this procedure to install the switch cover.
66
Chapter 4 Removal and replacement procedures
Battery on page
47).
Keyboard on page
61).
Spare part number
487139-001