3.1
StorEdge D1000 Disk Array Settings
This section describes how to set attributes for the StorEdge D1000
disk arrays (
1x2—One controller module with two StorEdge D1000 disk arrays
1x5—One controller module with five StorEdge D1000 disk arrays
2x7—Two controller modules with seven StorEdge D1000 disk arrays
3x15—Three controller modules with fifteen StorEdge D1000 disk arrays
For the D1000 disk arrays, you must set the following attributes:
Option switch
Module ID
SCSI jumper cables and terminators
FIGURE 3-1
3-2
Sun StorEdge A3500/A3500FC Hardware Configuration Guide • December 1999
) in the following configurations:
FIGURE 3-1
IN/OUT-1
IN/OUT-1
StorEdge D1000 Disk Array
Option switch
Module ID
IN/OUT -2
IN/OUT -2
Rear