Fc-Al Host Connections; Supported Fc-Al Host Configurations - Sun Microsystems Sun StorEdge A3500FC Configuration Manual

Hardware configuration guide

Hide thumbs Also See for Sun StorEdge A3500FC:

Table of Contents

Once you finish cabling the devices and powering on, reboot the system by

typing boot -r at the ok prompt before beginning any SCSI bus activity.

Perform a system check to make sure that SCSI and fiber-optic cable connections

are secure. Check for fault LEDs on the hardware or error messages in the RAID

Manager GUI.

Note – Refer to your server and rack documentation for instructions on grounding

the StorEdge A3500FC expansion cabinet.

2.2

The illustrations in this section show the FC-AL cable connections for the following

configurations:

Single Host Connected to One Controller Module

Independent Controller Module Connected to Two Hosts

Single Host Connected to One Controller Module Using Hubs

Single Host Connected to Two Controller Modules Using Hubs

Single Host Connected to Four Controller Modules in a Loop Using Hubs

Multi-Host

Chapter 2

FC-AL Host Connections

2-3

Table of Contents

Storedge a3500