Leaving The Setup Program - Epson 10020 User Manual

Leaving
the Setup Program
When you finish setting the options in the Setup menu,
highlight the
such as this:
Real-timeclock
Primary serial port
Secondary serial port
Check the list to see if all the information is correct. If any
setting is incorrect, highlight
Enter. The main Setup menu appears and you can change the
setting, as necessary.
If you did not make any changes or you want to cancel the
changes you made, highlight
and press Enter. The Operation menu appears on the screen.
Press 0 and Enter to return to the MS-DOS command prompt.
Note
If you changed the time or date, the new setting will be in
effect even if you exit the Setup program without saving
your changes.
If you want to save the settings you made, follow these steps:
1. Remove the Reference diskette from drive
option and press Enter. You see a summary
Exit
Time
Date
Baud rate 1200 bps
Data length 7 bits
Baud rate 1200 bps
Data length 7 bits
Change settings
E x i t w i t h o u t s a v i n g
** EXIT AND SAVE **
Changing DIP
Change settings
Exit without saving
Switches and
13:35:31
08-30-1989
Parity None
Stop bits 1 bit(s)
Parity None
Stop bits 1 bit(s)
and press
A.
Using Setup
A-13