Star Trac Spinner v Owner's Manual page 10

3. Install the Front Leg
NOTE: The front foot assembly has wheels attached to the front edge.
Be sure the wheels face forward when installing the front leg assembly.
Stand the bike frame upright and gently tip the front of the bike up and
position the front foot under the frame, with the wheels facing forward.
Attach the front foot assembly to the frame, aligning the holes in the foot
with the holes in the frame.
Position the leg so the thicker end and wheels face
toward the front of the bike
Using the 5mm hex wrench and a 13mm combination
wrench insert 2- M10X55mm (rear-most holes) and
2-M10X65mm (front-most holes) button head screws,
nuts and washers (under bolt head and nut), to secure
the front leg assembly to the frame.
Tighten all hardware securely using a torque wrench to 85 lbs-in.
Move the bike to a flat surface and adjust the four leveling feet so the
bike is stable.
4. Install the Saddle and Seat Slider
A.
Disengage pop-pin by loosening then pulling away from the
frame. While still holding onto the pop -pin, install the seat
post into the frame and lower it to the lowest position and
tighten the pop pin securely once again.
B.
Slide the seat slide into the top of the seat post with the saddle
pointed towards the front of the bike.
Rotate the seat slider lock knob as needed so that the slider
clamp is in alignment with the guide rail
There is a locking pin under the saddle that has to be pulled
up as you move the slider into position. Release the pin
when the indicator is within the 0 to 9 range.
Test the seat slide for proper operation and full travel.
Page 10
Step 3
Step 4A
Step 4B
SPINNER OWNER'S GUIDE
®